2018-06-03, 12:15 PM
How do I do that? Tried every combination of ports & ip address I can think of but nothing shows up in the diagnostic window. NMEA message is from another thread - $WIMWV,28,R,4.7,N,A*04
Node-red -
KPLEX -
Node-red -
Code:
[
{
"id": "eb4147d4.73a6d8",
"type": "inject",
"z": "3f30ea31.da3756",
"name": "",
"topic": "",
"payload": "$WIMWV,28,R,4.7,N,A*04",
"payloadType": "str",
"repeat": "1",
"crontab": "",
"once": false,
"onceDelay": 0.1,
"x": 220,
"y": 1380,
"wires": [
[
"137d8646.f9660a"
]
]
},
{
"id": "137d8646.f9660a",
"type": "function",
"z": "3f30ea31.da3756",
"name": "",
"func": "msg.payload = msg.payload + \"\\n\";\nreturn msg;",
"outputs": 1,
"noerr": 0,
"x": 480,
"y": 1420,
"wires": [
[
"5c27d805.90e408"
]
]
},
{
"id": "5c27d805.90e408",
"type": "udp out",
"z": "3f30ea31.da3756",
"name": "",
"addr": "10.10.10.1",
"iface": "",
"port": "6666",
"ipv": "udp4",
"outport": "",
"base64": false,
"multicast": "false",
"x": 680,
"y": 1440,
"wires": []
}
]KPLEX -
Code:
pi@openplotter:~ $ cat .kplex.conf
# For advanced manual configuration, please visit: http://www.stripydog.com/kplex/configuration.html
# Please do not modify defaults nor OpenPlotter GUI settings.
# Add manual settings at the end of the document.
###defaults
[udp]
name=system_a
direction=in
address=localhost
port=10110
[udp]
name=system_b
direction=in
port=10110
[tcp]
name=opencpn
direction=out
mode=server
ofilter=-**RMB
port=10109
[udp]
name=signalk
direction=out
ofilter=-OC***
address=127.0.0.1
port=55556
###end of defaults
###OpenPlotter GUI settings
[serial]
name=gps
direction=in
optional=yes
filename=/dev/ttyUSB0
baud=4800
[serial]
name=ais
direction=in
optional=yes
filename=/dev/ttyUSB1
baud=38400
[udp]
name=node
direction=in
optional=yes
address=10.10.10.1
port=6666
[udp]
name=tablet
direction=in
optional=yes
address=10.10.10.1
port=50000
###end of OpenPlotter GUI settings
###Manual settings