OpenMarine

I finally completed the initial setup. I am using an rpi3b as my plotter and Sean’s weather sensor, motor controller and pi zero running tiny pilot. I wired in a switch so I could easily revert back to the built in controls in the tiller master if I had a system crash. The gps and ais resides on the rpi 3 and the rest of the sensors are hooked to the zero. This allows me to sail apparent wind and magnetic heading without out firing up the plotter. However is I do all sensors talk via the A.P. built into the zero. Which allows me to also sail to a plotted course and gps/true wind settings.


Sent from my iPhone using Tapatalk

Awesome!!! thanks for sharing

(2019-04-24, 08:22 PM)Sailoog Wrote: [ -> ]Awesome!!! thanks for sharing

Accept now I sold the boat and have to come up with a non tiller set up of some sort.


Sent from my iPhone using Tapatalk