Upgrade from v0.10.0 to 0.17.0 causes Node & Signal K failure - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: Bug Reports (https://forum.openmarine.net/forumdisplay.php?fid=4) +--- Thread: Upgrade from v0.10.0 to 0.17.0 causes Node & Signal K failure (/showthread.php?tid=1012) |
Upgrade from v0.10.0 to 0.17.0 causes Node & Signal K failure - dcrowe - 2018-02-07 I thank you in advance for any assistance you can provide me. Raspberry Pi 3 with NMEA 0183 data present on UART input I installed v0.10.0 NOOBS from the Sailoog.com website and had all working nicely with a multiplexed NMEA 0183 output and a SignalK server running also. I was prompted by the Openplotter GUI to update to ver 0.17.0 and did so using the gui. After the update had finished all seemed well except that I could not see any SignalK data out using its test URL http://localhost:3000/ just an error message... Quote:This site can’t be reached NOTE: This all worked fine before the upgrade. I also note that when attempting to look at the NODE-RED config page http://localhost:1880/# the messages below are displayed ,and in the flow diagram.. "unknown: freeboard" is shown in a dashed box. Quote:Imported unrecognised type: Below is the output from the openplotter command... Code: pi@openplotter:~ $ openplotter Below is the output from the command node-red .... Code: pi@openplotter:~ $ node-red A number of forums have referred to the upgrade log files but alas I don't know where to find them. As I am a relative newbie to Linux and the Pi I would be extremely grateful if anyone could shed any light on this problem and perhaps give me some step by step instructions on how to fix this. Many thanks Dean. RE: Upgrade from v0.10.0 to 0.17.0 causes Node & Signal K failure - Sailoog - 2018-03-02 I have seen this bug before and we solved it but I can not remember how what happens if you disable the UART input? Update to 0.17.1 in case something went wrong with the last update RE: Upgrade from v0.10.0 to 0.17.0 causes Node & Signal K failure - Sailoog - 2018-03-02 This bug is related: http://forum.openmarine.net/showthread.php?tid=512 |