Heading and pressure disapeared from OCPN - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: Bug Reports (https://forum.openmarine.net/forumdisplay.php?fid=4) +--- Thread: Heading and pressure disapeared from OCPN (/showthread.php?tid=1103) |
Heading and pressure disapeared from OCPN - Didier B - 2018-04-06 All I2C (IMU, Pressure, humidity) disappeared after a reboot. I had to :
- What could be the reason of the info loss ? - is there a sure way to get everything back in an easier manner (like a backup of a conf Flle...) BTW I lost the opencpn config a few days ago ... RE: Heading and pressure disapeared from OCPN - Didier B - 2018-04-08 Surprisingly, this morning OP lauched as a charm, OCPN dashboard displaying heading, pitch, roll, etc. BUT after a forced reboot (shutdown + my switch on the RUN header) these values were not displayed in the OCPN Dashboard... RE: Heading and pressure disapeared from OCPN - topodom - 2018-04-08 (2018-04-06, 05:08 PM)Didier B Wrote: All I2C (IMU, Pressure, humidity) disappeared after a reboot. I had to : Hi Everyone, After reboot, I almost have the same issue. I2C sensors are displayed in signal K, but not in openCPN. 1- i use tool "NMEA 0183 Generator, which means delete all lines one by one, then use button OpenCPNdefault to get them back. 2 - they are back in OpenCPN RE: Heading and pressure disapeared from OCPN - Didier B - 2018-04-09 I could see in this Bug Reports Forum a number of occurrences of the loss of the generated NMEA sentences. I can understand it is hard to fix, as it seems to have a randomly behaviour. In my case it occurs, or not, after a cold start or a reboot. Anyway, I could find a different way to restore this data flow, by forcing a restart of signal k server (in OP Signal K tab). The NMEA sentences generator therefore seems OK, the bug seems to lye in signal K server. Hope the dev. team will eradicate it soon ... |