OpenMarine
openplotter with nasa ais 3 - Printable Version

+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3)
+--- Thread: openplotter with nasa ais 3 (/showthread.php?tid=1480)

Pages: 1 2

RE: openplotter with nasa ais 3 - Sailoog - 2018-09-16

If you have GPS or/and AIS data in your device I would recommend GPSD. If you have different data than GPS/AIS you have to use kplex.
GPSD allows you to access data from some apps simultaneously, can manage binary data and has some data optimization.

RE: openplotter with nasa ais 3 - rl82 - 2018-09-16

(2018-09-16, 06:58 PM)Sailoog Wrote: If you have GPS or/and AIS data in your device I would recommend GPSD. If you have different data than GPS/AIS you have to use kplex.
GPSD allows you to access data from some apps simultaneously, can manage binary data and has some data optimization.

Thanks very much I don't think the ais has gps.built in, I would just like to see what vessels are near by really so what would be best? Thanks so much

RE: openplotter with nasa ais 3 - rl82 - 2018-09-17

I still cannot seem to get anything logging, I connected the nasa ais 3 to my PC and installed some software and it logs this way, but not via the openplotter software on my pi, I set it to kplex?

Thanks very much

RE: openplotter with nasa ais 3 - Sailoog - 2018-09-17

In "Serial" tab set kplex as assignment and set bauds. Go to "kplex" tab and check "diagnostic"

RE: openplotter with nasa ais 3 - rl82 - 2018-09-18

thanks I pressed diagnostic nothing is showing up yet i'll leave it running to see if anything is logged
I am starting to get data shown under diagnostics, do I have to change anything on opencpn to view which vessels are nearby?

RE: openplotter with nasa ais 3 - Sailoog - 2018-09-18

You do not have to edit opencp connection default settings. Delete all you have done there and set only a network input:

protocol TCP
address localhost
port 10110

RE: openplotter with nasa ais 3 - rl82 - 2018-09-19

(2018-09-18, 06:00 PM)Sailoog Wrote: You do not have to edit opencp connection default settings. Delete all you have done there and set only a network input:

protocol TCP
address localhost
port 10110

thanks I have made those changes hopefully it will start showing soon