END KERNEL PANIC - NOT SYNCING: ATTEMPETED to kill init! exit code=0x0000004 - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2) +--- Thread: END KERNEL PANIC - NOT SYNCING: ATTEMPETED to kill init! exit code=0x0000004 (/showthread.php?tid=1799) |
END KERNEL PANIC - NOT SYNCING: ATTEMPETED to kill init! exit code=0x0000004 - pgorab - 2019-05-09 Hello Sailors, I am usig RPI 3 and the official raspberry power supply. I flashed and OP 10 image in a SD card (512Gb, formatted with SD Formatter and then transformed in FAT32 via diskutil console command in a Mac) and inserted the SD on the PI. I got the END KERNEL PANIC - NOT SYNCING: ATTEMPETED to kill init! exit code=0x0000004 and the system does not booting. (please see attached screen print) I was using OP 8 before and installed the 10 version and had no problem like it before. Please can somebody help me to solve it? Thanks a lot! Best Paulo RE: END KERNEL PANIC - NOT SYNCING: ATTEMPETED to kill init! exit code=0x0000004 - Saqqara - 2019-05-09 I don't think this post concerns Pypilot - you will want to ask in the Openplotter area of the forum where it may be seen by more people. RE: END KERNEL PANIC - NOT SYNCING: ATTEMPETED to kill init! exit code=0x0000004 - Sailoog - 2019-05-09 Moved to openplotter forum. Were you using that huge SD card before? I think you can not format as fat32 if the card is more than 32GB using some tools. Have you tried Etcher? https://www.raspberrypi.org/documentation/installation/installing-images/README.md RE: END KERNEL PANIC - NOT SYNCING: ATTEMPETED to kill init! exit code=0x0000004 - pgorab - 2019-05-10 (2019-05-09, 05:32 PM)Saqqara Wrote: I don't think this post concerns Pypilot - you will want to ask in the Openplotter area of the forum where it may be seen by more people. Hi Saqqara isn't it OpenMarine › OpenPlotter › General discussion? The idea is having more people helping![url=http://forum.openmarine.net/forumdisplay.php?fid=2][/url] (2019-05-09, 08:10 PM)Sailoog Wrote: Moved to openplotter forum. Yes I did it using Etcher which format in other format different of FAT32 (because the size of the card) and then I transformed in into FAT32. It already worked before several times with the same card. Now I have this message!!! Thanks for moving the thread to the right place! Paulo |