+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: Bug Reports (https://forum.openmarine.net/forumdisplay.php?fid=4)
+--- Thread: IMU and Temp/Hum sensor interference (/showthread.php?tid=182)
IMU and Temp/Hum sensor interference - Snijdor - 2016-08-10
Hello,
When I connect both the IMU and Temp/Hum sensor I get random garbled values on the temp/hum. When I disconnect or disable the IMU I get normal values on Temp/hum.
After a reset and restart the temp/hum is not detected anymore.
I've wired the SDA SDC tight together, I use a MPU-9250 IMU sensor and HKU and a HTU21D Temp/hum sensor.
Any ideas?
Regards
RE: IMU and Temp/Hum sensor interference - e-sailing - 2016-08-12
I have had the same problem.
I thought that i read about this issue already. I have got my imu and hum on the boat. So i can't look where the problem is. In the beginning i thought it was a hardware problem. But i'm pretty sure it has to do with the RTIMU library.
RE: IMU and Temp/Hum sensor interference - dione - 2016-10-06
Hello, i have the same problem with the same sensors. I have never seen the gyroscope. The sensor of humity HTU21 marks the humility and temperature, but sometimes it disappears and does not return to acknowledge it.
with both connected sensors, humidity measurement is not correct.
Sorry by my english
Saludos