Conversion of units in OpenPlotter - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: Conversion of units in OpenPlotter (/showthread.php?tid=1827) |
Conversion of units in OpenPlotter - gypsylyon - 2019-06-05 Continuing with the assembly of a Raspi mobile with a 7" screen, I installed the IMU9250. After the corresponding calibration it works perfectly. The problem is that the atmospheric pressure comes out in inHg(inches of mercury). I have tried with the Hut Moitesier and I also get it in inHg I've looked at Signal K and I don't see the possibility of converting it to millibars. Does anyone know how to do it? RE: Conversion of units in OpenPlotter - e-sailing - 2019-06-07 SignalK uses SI units (for pressure Pa). Do you see the wrong value in "diagnostic Signal K input" when "private Unit" is unchecked? If it does show you the correct value in Pa then you must change your "Unit Settings" (Setup your private Units (for diagnostic only)) RE: Conversion of units in OpenPlotter - gypsylyon - 2019-06-09 e-sailingSignalK uses SI units (for pressure Pa). [quote pid='9117' dateline='1559928543'] Do you see the wrong value in "diagnostic Signal K input" when "private Unit" is unchecked? If it does show you the correct value in Pa then you must change your "Unit Settings" (Setup your private Units (for diagnostic only)) [/quote] Thank you very much for your reply. What you propose I have already done, but the value does not change only the units |