How do I see DS18B20 sensor address - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: How do I see DS18B20 sensor address (/showthread.php?tid=1839) |
How do I see DS18B20 sensor address - pgorab - 2019-06-13 I am using OP 1.0 and wants to add a DS18B20 to my engine room. I have connected it to RPi via GPIO 4 though a module that comes with the sensor and I did not get any sensor address so I could add it to 1W tab. Secondly I put the module out of the equation and soldered the recommended resistor (4,7) and the cables directly connected to GPIO pins. I did not worked as well. I simply cannot see an address when I try to add it. Is there any way I can find sensor address? Does it should be recognized automatically in the 1W tab or do I need to insert even the address by hand? Thanks in advance! Paulo RE: How do I see DS18B20 sensor address - jim321 - 2019-06-13 it should be recognized automatically in the 1W tab |