Connect Victron Battery monitor to Openplotter SignalK? - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: Connect Victron Battery monitor to Openplotter SignalK? (/showthread.php?tid=387) Pages:
1
2
|
RE: Connect Victron Battery monitor to Openplotter SignalK? - PaddyB - 2017-12-29 (2017-12-29, 12:39 AM)Arne Wrote:(2017-12-28, 12:46 AM)PaddyB Wrote:(2017-12-27, 07:17 PM)Arne Wrote: I'm planning to buy myself a BMV-702, what do you use to connect it to the RPi, the original "Victron VE.Direct - USB Interface" ?? It's actually a mppt controller I have but the interface looks the same VE direct . 4 connectors, 5v, ground, rx & TX. I used dupont female wires to connect onto the pins, not ideal by far but works just. Thinking back (not on the boat today) it was probably an arduino mega as it has several serial in/out pins so victron TX onto arduino rx, rx to TX and ground. Arduino gets its power from usb. Then the win laptop found the victron straight away with the arduino echoing the 2 serial ports. RE: Connect Victron Battery monitor to Openplotter SignalK? - divingfortools2 - 2019-05-03 The connector is named "JST 2.0mm PH 4Pin" , the pinout and the logic is in the whitepaper "vedirect protocol" at the victron website RE: Connect Victron Battery monitor to Openplotter SignalK? - Arne - 2019-05-03 (2019-05-03, 09:44 AM)divingfortools2 Wrote: The connector is named "JST 2.0mm PH 4Pin" , the pinout and the logic is in the whitepaper "vedirect protocol" at the victron website Thanks. :-) I ended up buying the original cable, and have had it running for quite a while. |