New OpenPlotter v0.10.0alpha release - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2) +--- Thread: New OpenPlotter v0.10.0alpha release (/showthread.php?tid=462) |
RE: New OpenPlotter v0.10.0alpha release - Sailoog - 2017-04-26 thanks for your testing and feedback guys NMEA 0183 generator needs a general revision too. This is the road map: Now still working on Actions, then we will revise I2C and we will ad support for BME280 sensors (temp, hum, press), NMEA 0183 generator revision... Littlechay serial management has changed on RPI3 due to bluetooth addition. Some info: https://www.rhydolabz.com/wiki/?p=15764 Thanks to e-sailing for fixing NMEA generator and ADS1115 issues. RE: New OpenPlotter v0.10.0alpha release - abarrow - 2017-04-26 Regarding UART management, Adrian at Wegmatt (the creator of the dAISy Hat for RPI) has a nice little instruction on how to disable serial bluetooth connection on RPI3 and move it to GPIO: Open a terminal window on your Raspberry Pi and execute the following commands: 1. wget https://github.com/itemir/rpi_boat_utils/raw/master/uart_control/uart_control 2. chmod +x ./uart_control 3. sudo ./uart_control gpio 4. sudo reboot now RE: New OpenPlotter v0.10.0alpha release - Littlechay - 2017-04-26 (2017-04-26, 06:03 PM)Sailoog Wrote: Littlechay serial management has changed on RPI3 due to bluetooth addition. Some info: https://www.rhydolabz.com/wiki/?p=15764 I'll have a read but in OP 0.9 the permissions problem did not exist. very odd! RE: New OpenPlotter v0.10.0alpha release - Littlechay - 2017-04-27 (2017-04-26, 06:35 PM)abarrow Wrote: Regarding UART management, Adrian at Wegmatt (the creator of the dAISy Hat for RPI) has a nice little instruction on how to disable serial bluetooth connection on RPI3 and move it to GPIO: I don't quite get what is going on but yes that releases ttyAMA0 and the GPS HAT appears there. I change my serial port in the NMEA 0183 tab of OP to ttyAMA0 and I have the serial port available after a reboot. All good. But I guess openplotter needs to test for RPi 3 and sort that out on install otherwise people are going to have trouble. thanks RE: New OpenPlotter v0.10.0alpha release - dcrowe - 2018-02-13 (2017-04-12, 05:48 PM)Sailoog Wrote: Hi OP user, Is this the reason why my upgrade... [Upgrade from v0.10.0 to 0.17.0 causes Node & Signal K failure] fails? Details in this post-http://forum.openmarine.net/showthread.php?tid=1012I would be very grateful for any advice. it's been seen dozens of times but with no replies. Many thanks Dean |