+- OpenMarine (https://forum.openmarine.net)
+-- Forum: Pypilot (https://forum.openmarine.net/forumdisplay.php?fid=17)
+--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=18)
+--- Thread: calibration screen in new OP image Using VNC , wrong (/showthread.php?tid=4822)
calibration screen in new OP image Using VNC , wrong - winkaj - 2023-08-06
Pypilot calibration screen
In the new OP image 64bit .
is wrong . when using VNC .
See picture
If i conect a HDMI screen . it become Ok , both in HDMI and VNC .
But after disconect of HDMI . it become wrong again in VNC used from another computer .
RPI 3B , and Hacked HAT ,
Danish
RE: calibration screen in new OP image Using VNC , wrong - seandepagnier - 2023-08-06
This is a bug in vnc?
Can you run pypilot_calibration locally instead of on vnc? or use the web interface?
RE: calibration screen in new OP image Using VNC , wrong - winkaj - 2023-08-06
(2023-08-06, 07:20 PM)seandepagnier Wrote: This is a bug in vnc?
Can you run pypilot_calibration locally instead of on vnc? or use the web interface?
I can run pypilot_calibration locally it works when i have connected af HDMI screen .
Is the same bug affecting Chromium Netbrowser ?
I have to install Firefox to start Signal K .
RE: calibration screen in new OP image Using VNC , wrong - seandepagnier - 2023-08-06
I mean you can run pypilot_calibration on any machine and pass it the ip address of the one with pypilot.
if you have the pypilot_web service started you can use a browser to view the calibration that way.
RE: calibration screen in new OP image Using VNC , wrong - winkaj - 2023-08-06
(2023-08-06, 08:37 PM)seandepagnier Wrote: I mean you can run pypilot_calibration on any machine and pass it the ip address of the one with pypilot.
if you have the pypilot_web service started you can use a browser to view the calibration that way.
I tried to enable pypilot_web . but now i have lost the Pi on the network .
There is bad weather here i denmark , so i will first be on my boat , in wensday i think .