OpenMarine
Had to replace mine - Printable Version

+- OpenMarine (http://forum.openmarine.net)
+-- Forum: CAN-USB Stick (http://forum.openmarine.net/forumdisplay.php?fid=11)
+--- Forum: Bug Reports (http://forum.openmarine.net/forumdisplay.php?fid=14)
+--- Thread: Had to replace mine (/showthread.php?tid=687)



Had to replace mine - joabakk - 08-15-2017

I bought one of these a while ago, and I tested it successfully with the rpi setup. Only when I added all other inputs, it stopped translating sentences. Paste from my slack #support message: 

Code:
I’m losing n2k sooner or later on every reboot. If I start canbus manually, I get
```signalk-server-node $ actisense-serial /dev/n2k
FATAL 2017-07-30T18:50:57.385Z [actisense-serial] Unable to read from NGT1 device
```
after 1, 10 or 100 lines. Is this normal? I’m using the can-usb from openplotter rather than the ngt-1. Any ideas anyone?

After replacing the dongle I bought from openplotter with an NGT-1, n2k works fine again