GPIO action setup issue - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: GPIO action setup issue (/showthread.php?tid=924) |
GPIO action setup issue - ottow - 2018-01-05 Hi, I just moved to OP 0.10.0 Alpha (from a much older OP version), and am struggling with setting up GPIO actions. What worked previously is not working now... I am looking to trigger a system shutdown when GPIO27 is connected to GND I've set it up as below for testing: However, when I connect Pin9 (GND) to Pin13 (GPIO27) nothing happens. This used to work in the older version I was running (although the setup was slightly different). What am I doing wrong here? RE: GPIO action setup issue - jim321 - 2018-01-05 first thing is to UPDATE.....lots of fixes since v0.10.0 my tab says gpio not gpio sensors there are reboot shutdown ect all in the actions tab..where you have show message RE: GPIO action setup issue - ottow - 2018-01-05 I prefer to use the Stable branch rather than the Beta if at all possible. I believe I read somewhere that once switched to use the Beta branch I would be unable to switch back to Stable. And yes, I know I've configured it to only show a message. This is intentional, once working I will switch it to Shutdown. RE: GPIO action setup issue - jim321 - 2018-01-05 v0.11.2 Fix Actions. Some actions need still to be revised but triggers are working right. Stop and start all actions needs revision too v0.11.3 New interface for actions. Parsing signal k values on actions data. Fix Twwitter and Gmail actions Fix SMS actions Fix sounds actions Fix messages actions Fix wait, reset, shutdown, startup stop, startup restart actions v0.11.5 Fix GPIO output actions v0.11.7 Add Set Signal K key value action Improve error messages in actions v0.15.0 Fix issue with actions and I2C v0.16.0 Fix issue with multilanguage actions and operators Fix timestamp issue in actions the beta is very stable. there should be a new image soon i am expecting a stable one once the new hats go on sale.last eta was the end of this month..then you can update to stable again.. or you could just wait for it.... RE: GPIO action setup issue - ottow - 2018-01-06 Upgraded to latest version and the issue is gone. RE: GPIO action setup issue - jim321 - 2018-01-06 ....... |