2021-03-01, 11:41 PM
Hello all
I have just started out on my project to use the open source software on my sail boat and therefore I apologise if I.m starting out with a really dumb question.
I have dug through previous posts but I may not have phrased my searches right when trying to find 'like problems' on this forum, so I am more than happy to be told to go off and read xyz etc.
My problem is that I bought an Adafruit 9dof which comes up and is recognised as an IMU using BNX055 etc via Pyplotter however, I can't seem to get a compass heading or a temperature or pressure reading out of it no matter what I do. I have tested the IMU using a Python script and I get changes in values when running the script and moving the IMU around so it's not the pcb. I did get a feasible pressure reading but not temperature reading when I set the sensor to MS5607-02BA03.
Can I kindly seek your collective wisdom to send me off in the right direction.
The IMU - https://thepihut.com/products/adafruit-9...out-bno055
Kind regards
Steve
I have just started out on my project to use the open source software on my sail boat and therefore I apologise if I.m starting out with a really dumb question.
I have dug through previous posts but I may not have phrased my searches right when trying to find 'like problems' on this forum, so I am more than happy to be told to go off and read xyz etc.
My problem is that I bought an Adafruit 9dof which comes up and is recognised as an IMU using BNX055 etc via Pyplotter however, I can't seem to get a compass heading or a temperature or pressure reading out of it no matter what I do. I have tested the IMU using a Python script and I get changes in values when running the script and moving the IMU around so it's not the pcb. I did get a feasible pressure reading but not temperature reading when I set the sensor to MS5607-02BA03.
Can I kindly seek your collective wisdom to send me off in the right direction.
The IMU - https://thepihut.com/products/adafruit-9...out-bno055
Kind regards
Steve