I have 3 inputs to my MCP3208 ADC configured as tank level sensors.
In OP I have allocated SK tags to each I/Pl
(Fuel.currentvolume, Fresh Water.currentvolumeand Wast Water.currentvolume)
I can see SignalK data from any one of the channels if I set only 1 of them to be active but if I set more than 1 to be active, I get no data.
Thanks
Steve
In OP I have allocated SK tags to each I/Pl
(Fuel.currentvolume, Fresh Water.currentvolumeand Wast Water.currentvolume)
I can see SignalK data from any one of the channels if I set only 1 of them to be active but if I set more than 1 to be active, I get no data.
Thanks
Steve