Need help here. I have an D1 Mini which I previously have run I2C connection to a MPU 9250 on and it have worked flawless. Now I want to change it and use it with a ADS 1115 to monitor my batteries instead, but I can not get it to work. I have changed //#define ENABLE_MPU for #define ENABLE_ADS1115 in config.h, and I2C is of course enabled. When I look at the serial monitor i see "Scanning for i2c Sensors..." but when I look for it through my browser in <IP adress>/getSensorinfo, I get nothing. When I try to set <IP adress>/setSensorAttr?address=0x48&attrName=diff0_1&path=vessels.electrical.batteries.voltage I get the error message: { "success": false }
I plan to hook up a Hall sensor (https://www.ebay.co.uk/itm/ACS758LCB-050...3091956413) and a 0-25V sensor (https://www.ebay.co.uk/itm/222848285280) to monitor my current (pun intended...) battery status by sending data over signalK - possibly by tweaking it in NodeRed - but first I have to get this damned thing to work! ;-)
I plan to hook up a Hall sensor (https://www.ebay.co.uk/itm/ACS758LCB-050...3091956413) and a 0-25V sensor (https://www.ebay.co.uk/itm/222848285280) to monitor my current (pun intended...) battery status by sending data over signalK - possibly by tweaking it in NodeRed - but first I have to get this damned thing to work! ;-)