2022-04-03, 07:21 AM
I would like to set a PGN in the ' manufacturers range' on my actisense NGT-1, above 130816, but am not able to.
At the start I could not get the PGNs to pop up at all, until I figured out that I had more than 30 enabled. After resetting the device, it nicely showed the list of PGNs and I am able to set ' lower values'.
I can check the box, but it simply ' doesn't stick', after the pop up to set it, it returns and empties out the checkbox.
Tried starting openplotter-can from command prompt, but only see the signalk start/stop messages, nothing else that could help troubleshooting.
Any suggestions?
At the start I could not get the PGNs to pop up at all, until I figured out that I had more than 30 enabled. After resetting the device, it nicely showed the list of PGNs and I am able to set ' lower values'.
I can check the box, but it simply ' doesn't stick', after the pop up to set it, it returns and empties out the checkbox.
Tried starting openplotter-can from command prompt, but only see the signalk start/stop messages, nothing else that could help troubleshooting.
Any suggestions?