2018-09-28, 07:45 AM
Anybody knows about possibility of using GPS USB receiver as GPS receiver?
Openplotter hardware (GPS receiver)
|
2018-09-28, 07:45 AM
Anybody knows about possibility of using GPS USB receiver as GPS receiver?
2018-09-28, 03:17 PM
It should be okay, as long as you give it enough power. You may have to plug it into a powered USB hub. That's what I do with this one.
I'm just about to change over to this. It requires external 5v supply and an RS-232 converter, but it can be mounted on a stern rail and should give better sensitivity. I chose the RS232 version because I ultimately want to run it through an RS485 converter and directly output NMEA strings.
tested a few all have worked out of the box strait into the pi no power problems at all
2018-09-29, 10:17 PM
Thanks for all. I want to buy it for using in openplotter.
2018-09-30, 12:16 PM
The one in your post works out of the box in my set-up.
2018-10-01, 06:51 PM
I used one of these gps usb on board for a 4 weeks summer cruise, without any inconvenient. On my (aluminium) boat is a big plexiglas "buble" (1 sqm) under which it is located. It is connected through a powered usb hub, and it worked flawlessly without even powering the hub !
I guess in a fiberglass boat you can locate it under the deck, far from any metallic gear, avoiding any corrosion or water inlet.
Cordialement
Didier B Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you |
« Next Oldest | Next Newest »
|