This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
sampling frequency
#1
Hi,

I am using setting up Node-Red in openplotter to get feed from SignalK and from the 1W DS18B20 sensor, as well as a voltage sensor through MCP3008. I wanted to plot the reading history for the last 24 hours. However I found that there were too many data points. How do I set the sampling or poll frequency in this case? I searched around SignalK setting did not find anything.

Thank you in advance.
Reply
#2
Have you considered using influxdb and chronograph/grafana for reading history? in SK-influxdb plugin you can set that frecuency you need.
Install openplotter-dashboards app in openplotter 2
Reply
#3
https://flows.nodered.org/node/node-red-...b20-sensor

https://flows.nodered.org/node/node-red-node-pi-mcp3008
Reply
#4
(2019-11-27, 12:20 PM)Sailoog Wrote: Have you considered using  influxdb and chronograph/grafana for reading history? in SK-influxdb plugin you can set that frecuency you need.
Install openplotter-dashboards app in openplotter 2

I have not tried that, I will give it a try...thank you.

(2019-11-27, 12:20 PM)jim321 Wrote: https://flows.nodered.org/node/node-red-...b20-sensor

https://flows.nodered.org/node/node-red-node-pi-mcp3008

thank you. are you suggesting to use "timestamp" as a way to control the frequency?
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)