2020-02-12, 12:06 PM
Hello Sean and everyone,
I am attempting to use the Monster Moto Shield as my motor driver with an Arduino Uno. Wired everything up, powered up and my motor won't budge, even with a PWM of 100%.
Pulled DMM to measure 0.54V in one direction and 1.84V in the other on the output pins.
Then took out the motor and again DMM: 1.84V in both directions.
Input is a healthy 12.4V lead acid battery. Any idea as to what might be going on ?
Thank you
I am attempting to use the Monster Moto Shield as my motor driver with an Arduino Uno. Wired everything up, powered up and my motor won't budge, even with a PWM of 100%.
Pulled DMM to measure 0.54V in one direction and 1.84V in the other on the output pins.
Then took out the motor and again DMM: 1.84V in both directions.
Input is a healthy 12.4V lead acid battery. Any idea as to what might be going on ?
Thank you