2019-09-23, 06:09 PM
thanks i will try this…. ;-)
Yes, I think about the auto-shutdown and further i have 4 more opto-Inputs on the board wich can use for switches or so on.
If you have some time, you can take a quick look at my Postinstall.py script? If it is o.k. for you I make the preuninstall to delete all changes?
https://github.com/Thomas-GeDaD/openplot...plotterMCS
For the I2C devices I must call "echo ds2482 0x18 > /sys/bus/i2c/devices/i2c-1/new_device". Is the startup.py the right place for it?
Yes, I think about the auto-shutdown and further i have 4 more opto-Inputs on the board wich can use for switches or so on.
If you have some time, you can take a quick look at my Postinstall.py script? If it is o.k. for you I make the preuninstall to delete all changes?
https://github.com/Thomas-GeDaD/openplot...plotterMCS
For the I2C devices I must call "echo ds2482 0x18 > /sys/bus/i2c/devices/i2c-1/new_device". Is the startup.py the right place for it?