2020-01-08, 08:01 PM
(This post was last modified: 2020-01-08, 08:02 PM by seandepagnier.)
Are you able to set the max current from the web? I should make the slew settings possible there.
Otherwise, the opencpn plugin and signalk_client_wx can set it, or ssh:
ssh tc@192.168.14.1
sudo sv d pypilot
nano ~/.pypilot/pypilot.conf
sudo sv u pypilot
What values are you using?
also, "SATURATION" is not an error really, it just means the motor isn't fast enough to keep up with the commands. The fault that might be triggered is OVERCURRENT if the slew is too fast.
Otherwise, the opencpn plugin and signalk_client_wx can set it, or ssh:
ssh tc@192.168.14.1
sudo sv d pypilot
nano ~/.pypilot/pypilot.conf
sudo sv u pypilot
What values are you using?
also, "SATURATION" is not an error really, it just means the motor isn't fast enough to keep up with the commands. The fault that might be triggered is OVERCURRENT if the slew is too fast.