2020-04-11, 04:28 PM
Hi Group,
I am very new to the OpenPlotter so please bear with a "green" question.
I recently received and installed a Moitessier HAT2 on my RPi3B+. It is working well. However, I previously had a SwitchDoc Labs INA3221 breakout board attached to the GPIO header on the RPi3 to measure boat battery voltages. How would I attach a breakout board now that the GPIO header is used by the HAT?
Thank you in advance for feedback. Tom
I am very new to the OpenPlotter so please bear with a "green" question.
I recently received and installed a Moitessier HAT2 on my RPi3B+. It is working well. However, I previously had a SwitchDoc Labs INA3221 breakout board attached to the GPIO header on the RPi3 to measure boat battery voltages. How would I attach a breakout board now that the GPIO header is used by the HAT?
Thank you in advance for feedback. Tom