(2020-04-24, 11:09 AM)Sailoog Wrote: verkerkbr, 55327 ppm is not possible. Maybe you have just removed the point from 55.327? try 55.
OnlyTieBowline, I have that device and they do not need almost calibration because its ppm will be always near 0, so -500 is not possible either.
What about your antennas?
Hi Sailoog,
that is what software says. No decimal ! Therefore I removed the decimal point,.
Because the PPM also comes with a decimal. Therefore I added this to the PPM setting. But after the warning, I removed the decimal point.
Regards,
Bram
(2020-04-24, 11:41 AM)verkerkbr Wrote:(2020-04-24, 11:09 AM)Sailoog Wrote: verkerkbr, 55327 ppm is not possible. Maybe you have just removed the point from 55.327? try 55.
OnlyTieBowline, I have that device and they do not need almost calibration because its ppm will be always near 0, so -500 is not possible either.
What about your antennas?
Hi Sailoog,
that is what software says. No decimal ! Therefore I removed the decimal point,.
Because the PPM also comes with a decimal. Therefore I added this to the PPM setting. But after the warning, I removed the decimal point.
Regards,
Bram
After changing the PPM to 55 instead of PPM with the decimal. I can report that the Ais RTL dongle is now working showing AIS object on the OpenCPn screen.
Thank for the advice. But it is a little confusing because in in the also the PPM with the decimals were used.
This is on my AMD64 Mint Tricia.
Regards,
Bram