2021-04-10, 06:03 PM
@abarrow Thanks to your tips I managed to make it work ^^
Watching at the stream with the "cat" command, i tried all possible wiring options (note: the good one was NMEA+ to A+ and NMEA- to GND), and adjusted the baud rate until i could see properly encoded NMEA messages (it was 4800 baud rate).
So all good! Now i have depth information distributed to all devices.
Thanks!
Watching at the stream with the "cat" command, i tried all possible wiring options (note: the good one was NMEA+ to A+ and NMEA- to GND), and adjusted the baud rate until i could see properly encoded NMEA messages (it was 4800 baud rate).
So all good! Now i have depth information distributed to all devices.
Thanks!