Just to confirm after installation openplotter from the scratch (openplotter-i2c version 3.3.7):
pi@openplotter:~/work $ i2cdetect -y 1
0 1 2 3 4 5 6 7 8 9 a b c d e f
00: -- -- -- -- -- -- -- --
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
30: -- -- -- -- -- -- -- -- 38 -- -- -- -- -- -- --
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
60: -- -- -- -- -- -- -- -- 68 -- -- -- -- -- -- --
70: -- -- -- -- -- -- -- 77
IMU: ICM-20948 (address 0x68, pypilot 3.2.6, SEN-15335) - detected and working
BMP280 - 0x77 detected and working
AHT20* - 0x38 detected and working
Good job!
*)AHT20 added to I2C sensors by myself
pi@openplotter:~/work $ i2cdetect -y 1
0 1 2 3 4 5 6 7 8 9 a b c d e f
00: -- -- -- -- -- -- -- --
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
30: -- -- -- -- -- -- -- -- 38 -- -- -- -- -- -- --
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
60: -- -- -- -- -- -- -- -- 68 -- -- -- -- -- -- --
70: -- -- -- -- -- -- -- 77
IMU: ICM-20948 (address 0x68, pypilot 3.2.6, SEN-15335) - detected and working
BMP280 - 0x77 detected and working
AHT20* - 0x38 detected and working
Good job!
*)AHT20 added to I2C sensors by myself