2023-06-03, 09:21 AM
(2023-06-01, 02:11 PM)apshamilton Wrote: I have set up Open Plotter 3 on a RPi4 with a PiCAN M hat with a GY-91 module (combined BMP-280 and MPU9250) connected to the I2C port of the PiCAN-M.
The system is completely up to date.
I have been following the instructions in this blog / video: https://jeremyclark.ca/wp/nav/openplotter-sensors_a/
I am able to connect the BMP-280 and get temperature and pressure data into Signal K, although the connections tab in I2C is missing (has it recently been removed?)
However PyPilot does not detect the MPU9250 IMU even though its address of 0068 is showing up.
Any advice on how I get the IMU to be detected.
I am also just starting to install OpenPlotter on a RPi 4 and have reached the stage of wanting to configure the GY-91 module.
The Configuration Tab shown in I2C 2.2.1 in the instructions does not appear in PyPilot 3.2.11-stable or I2C 3.3.12-stable.
As a complete novice I'm not sure how to resolve this issue?