2023-06-15, 05:25 AM
(This post was last modified: 2023-06-15, 07:27 AM by baltika_no_9.)
Alan
You seem to be doing things in a different order to me.
"Opened signalk in chromium and logged in as admin on the signalk server.then started the i2c setup.
. started i2c, Click approve, do the next steps. click apply. click refresh and get the you must approve the request message. "
A lot has gone on there - log in, approve, next steps, apply, refresh etc all before you get the approve the request message.
In my sequence there is none of that, the very first thing to do in OP is to go to Openplotter>I2C and you should get the you need to approve the request message at the very first step. Close I2C for now.
After doing the above (Openplotter>I2C - get the approval request message), can you follow these 3 steps and show the equivalent of these screenshots on your system?
1. Go into OpenPlotter>Signal K with your admin credentials. In Access requests, double click the OpenPlotter I2C identifier, enter NEVER and Read/Write and click the big red approve button.
2. The system will return to the access requests page but it will (should) be blank as shown, there are no outstanding requests as below
3. Then reopen Openplotter>I2C and at the bottom is should say "The access request was successfully approved" as you can see.
Can we compare that with what you see so we can concentrate just on this particular issue at least as it is very relevant.
You ask ".. is there a data connection in signalK I have to set up before the i2c?", well all I can say is that I have never ever had to.
You seem to be doing things in a different order to me.
"Opened signalk in chromium and logged in as admin on the signalk server.then started the i2c setup.
. started i2c, Click approve, do the next steps. click apply. click refresh and get the you must approve the request message. "
A lot has gone on there - log in, approve, next steps, apply, refresh etc all before you get the approve the request message.
In my sequence there is none of that, the very first thing to do in OP is to go to Openplotter>I2C and you should get the you need to approve the request message at the very first step. Close I2C for now.
After doing the above (Openplotter>I2C - get the approval request message), can you follow these 3 steps and show the equivalent of these screenshots on your system?
1. Go into OpenPlotter>Signal K with your admin credentials. In Access requests, double click the OpenPlotter I2C identifier, enter NEVER and Read/Write and click the big red approve button.
2. The system will return to the access requests page but it will (should) be blank as shown, there are no outstanding requests as below
3. Then reopen Openplotter>I2C and at the bottom is should say "The access request was successfully approved" as you can see.
Can we compare that with what you see so we can concentrate just on this particular issue at least as it is very relevant.
You ask ".. is there a data connection in signalK I have to set up before the i2c?", well all I can say is that I have never ever had to.