This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
IMU not detected - GY-91 sensor module (BMP-280 & MPU9250)

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
IMU not detected - GY-91 sensor module (BMP-280 & MPU9250)
Tom60 Offline
Junior Member
**
Posts: 14
Threads: 1
Joined: Jun 2023
Reputation: 0
#17
2023-06-17, 07:30 AM
Well I have the pressure and temperature back. I suspect I had the SCA and SCL pins reversed. (my error.. old eyes).

Running i2cdetect -y 1 from the Terminal shows addresses 68 and 76

I suspect 68 is the IMU as 76 is the BMP820.

However PyPilot 3.2.13 shows 'Detected IMU: none' with the 'Enable IMU Only' option
Find
Reply


Messages In This Thread
RE: IMU not detected - GY-91 sensor module (BMP-280 & MPU9250) - by Tom60 - 2023-06-17, 07:30 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)