2023-07-18, 12:30 PM
(This post was last modified: 2023-07-18, 12:31 PM by Jean-Marc Douroux.)
Hello Sean, I hope you are recovering well.
To avoid interference, I have chosen to put your Pypilot computer on a panel against the hull, 50 cm above the level of the chart table and 15cm below the deck and 30cm from the electrical panel where there is no no high current.
To disturb the magnetometers with this installation, it would be necessary to put metal outside the hull, 15 cm below deck level at the level of the computer.
To avoid interference, I have chosen to put your Pypilot computer on a panel against the hull, 50 cm above the level of the chart table and 15cm below the deck and 30cm from the electrical panel where there is no no high current.
To disturb the magnetometers with this installation, it would be necessary to put metal outside the hull, 15 cm below deck level at the level of the computer.