(2024-04-23, 04:27 PM)Sully Wrote: I definitely didn't use mosfets nor resistors. I'm connecting it directly to the socket of the MacArthur Hat.
Did I burn the IMU? I'm surely learning a lot with these projects haha!
Anyways I'm going to try to detect it using the method you mentioned.
Edit: didn't work.
I'm in the same boat. I bought the ICM-20948 Sensor Module 9 Axis MEMS Motion Tracking Device Sensor CJMCU-20948 because it was the recommended one and I have it connected to the MacArthur hat via the IMU header.
It is randomly detected but nothing happens when I try to calibrate it & then it has "disappeared" until the next re-boot.
I tried i2c-detect -y 1 but got the following???
If this IMU is no good what is the recommendation??
TIA
Pi5 8GB, NVME SSD 512GB, MacArthur hat, OP4