Hi,
I've just built a prototype of a wide sensor for my boat using parts of the weathersensor code from pypilot based on an Arduino Nano. I could of course use the NMEA0183 output as pypilot is doing but I also have an ethernet shield available so I was thinking of going directly for signal-k instead of over NMEA. Is there anyone who has done this?
It is so much to read up on (being new to openplotter) so a pointer on how to go about this would be really appreciated (unless it is a stupid idea -??)
The reason for not using the pypilot full implementation is also that I already have the barometric sensor in openplotter (directly on the PI3) and that my wind instruments are 4-20mA units so that is different from the pypilot implementation anyhow...
Any insight or ideas?
/Lars
I've just built a prototype of a wide sensor for my boat using parts of the weathersensor code from pypilot based on an Arduino Nano. I could of course use the NMEA0183 output as pypilot is doing but I also have an ethernet shield available so I was thinking of going directly for signal-k instead of over NMEA. Is there anyone who has done this?
It is so much to read up on (being new to openplotter) so a pointer on how to go about this would be really appreciated (unless it is a stupid idea -??)
The reason for not using the pypilot full implementation is also that I already have the barometric sensor in openplotter (directly on the PI3) and that my wind instruments are 4-20mA units so that is different from the pypilot implementation anyhow...
Any insight or ideas?
/Lars