2018-02-06, 10:38 PM
(This post was last modified: 2018-03-30, 05:13 PM by Didier B.
Edit Reason: mstyping
)
Hi,
How should I connect the NMEA output of my ST50 tridata repeater to the USB 422/485 adapter ? (see attachments)
On the ST50 instrument side are 2 wires 1 "signal" (red) and one "Ground" (blue) ;
On the adapter 5 screw connectors : R-, R+, T-, T+ and GND ;
I checked a signal is present on the ST50 equipment side (analogue multimeter, range 10VDC, the needle moves) ;
I tried, but without success these connections :
How should I connect the NMEA output of my ST50 tridata repeater to the USB 422/485 adapter ? (see attachments)
On the ST50 instrument side are 2 wires 1 "signal" (red) and one "Ground" (blue) ;
On the adapter 5 screw connectors : R-, R+, T-, T+ and GND ;
I checked a signal is present on the ST50 equipment side (analogue multimeter, range 10VDC, the needle moves) ;
I tried, but without success these connections :
- blue to GND, red to R+
- blue to R- red to R+
- blue to T-, red to T+
- blue to GND, red to T+
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you