UDP Issues - UDP message to SignalK from ESP8266

[holgerw]

FYI:

After an Problem where i only got the first Sentence out of my UDP Stream with the
normal Netcat:
$ nc -ul portnumber

found this solution by adding an timeout 1sek:
$ nc -kluvw 1 xxx.xxx.xxx.255 portnumber
or
$ nc -kluvw 1 portnumber
(if you are on the same host)

why i did this? I found these NMEA Strings from my UBLOX-7 USB Stick.
Pretty shure they are new, never saw these before....

$IIHDG,356.26,,,,*7D
$IIZDA,120111.020,29,04,2020,,*4E
$GPVTG,,T,,M,0.028,N,0.052,K,A*2E
$GPGGA,120111.00,4818.36018,N,01418.21870,E,1,06,1.65,250.8,M,43.9,M,,*52
$GPGSA,A,3,12,25,14,02,26,31,,,,,,,2.62,1.65,2.04*05
$GPGSV,4,1,13,02,31,051,39,05,06,095,,06,07,032,09,12,36,100,20*73
$GPGSV,4,2,13,14,18,260,36,18,17,180,14,21,15,188,,24,00,158,*7F
$GPGSV,4,3,13,25,69,094,20,26,11,292,20,29,77,241,10,31,44,298,45*79
$GPGSV,4,4,13,32,08,238,15*4F
$GPGLL,4818.36018,N,01418.21870,E,120111.00,A,A*62
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58
$GPTXT,01,01,01,NMEA unknown msg*58


Checksums are fine, the Position takes longer in my opinion. Has someone a Clue on this?

Holger