Good morning
I'm new to all this and only used openplotter to send AIS data to my laptop so far.
I'm more trying to get data from my wind sensor but looking at the wiring I don't think it's NMEA, although my understanding is very limited so I may be wrong.
The unit is wired as follows...
Red = +5v
White = speed
Blue = direction
Black = direction also
Screen = -ve
Is there any way I can get this unit to talk to openplotter?
Any help or suggestions would be very appreciated.
Thank you
Cy
Sent from my Swift 2 using Tapatalk
Sorry, I forgot to state..
I'm using
RPi 3
OP v0.8
Thanks
Sent from my Swift 2 using Tapatalk
I'm new to all this and only used openplotter to send AIS data to my laptop so far.
I'm more trying to get data from my wind sensor but looking at the wiring I don't think it's NMEA, although my understanding is very limited so I may be wrong.
The unit is wired as follows...
Red = +5v
White = speed
Blue = direction
Black = direction also
Screen = -ve
Is there any way I can get this unit to talk to openplotter?
Any help or suggestions would be very appreciated.
Thank you
Cy
Sent from my Swift 2 using Tapatalk
Sorry, I forgot to state..
I'm using
RPi 3
OP v0.8
Thanks
Sent from my Swift 2 using Tapatalk