This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
Looking for suggestions on my planned setup

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Looking for suggestions on my planned setup
Saqqara Offline
Member
***
Posts: 180
Threads: 39
Joined: Mar 2016
Reputation: 6
#6
2018-03-29, 11:10 PM (This post was last modified: 2018-03-30, 01:30 AM by Saqqara.)
Seems like stashing the UDOO somewhere at the helm (perhaps enclosed behind one of the screens) solves more problems than it creates and lets you drill fewer and smaller holes in your boat.

Also, router may not be necessary, and there is a canbus dongle solution for Openplotter, but I don't know how well it works.
Find
Reply


Messages In This Thread
RE: Looking for suggestions on my planned setup - by Saqqara - 2018-03-29, 11:10 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)