2016-06-06, 12:12 PM
GPSD setting looks fine
I have reinstalled openplotter on a new SD card, and updated/upgraded to latest release today.
In debug mode I get the following when applying changes after adding serial:
pi@openplotter:~ $ python /home/pi/.config/openplotter/openplotter.py
/home/pi/.config/signalk-server-node/bin/openplotter: line 4: 1741 Segmentation fault $DIR/signalk-server -s ./settings/openplotter-settings.json $*
I've tried to run Open CPN (on Open Plotter) but it will not start. Is this related to problem above or is something else going on??
OpenCPN works fine when installed on a pure Jessie distro, including getting GPS working and getting 10+ satellites and "green" NMEA messages in "NMEA debug window".
//Oskar
I have reinstalled openplotter on a new SD card, and updated/upgraded to latest release today.
In debug mode I get the following when applying changes after adding serial:
pi@openplotter:~ $ python /home/pi/.config/openplotter/openplotter.py
/home/pi/.config/signalk-server-node/bin/openplotter: line 4: 1741 Segmentation fault $DIR/signalk-server -s ./settings/openplotter-settings.json $*
I've tried to run Open CPN (on Open Plotter) but it will not start. Is this related to problem above or is something else going on??
OpenCPN works fine when installed on a pure Jessie distro, including getting GPS working and getting 10+ satellites and "green" NMEA messages in "NMEA debug window".
//Oskar