2018-07-08, 10:12 PM
I am running OP 1.0.2 on a RPi 3 with OpenCPN 4.8.4
At home using a 10" hdmi display everything runs fine. On my boat I use a Faytech 10" display. The system starts up normally, OP is started, but hangs at the command
'checking 400 x 800 display' and keeps hanging. The Faytech display did work with older OP versions.
Ik know the Faytech display needs an Egalax driver and this driver is installed. Any further suggestions?
Regards, Andries
At home using a 10" hdmi display everything runs fine. On my boat I use a Faytech 10" display. The system starts up normally, OP is started, but hangs at the command
'checking 400 x 800 display' and keeps hanging. The Faytech display did work with older OP versions.
Ik know the Faytech display needs an Egalax driver and this driver is installed. Any further suggestions?
Regards, Andries