This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adafruit LSM303DLHC
#1
I'm fairly new to OpenPlotter and i'm not a software engineer. Have set up version 1.0.2 on a Rpi3 and now have an Adafruit chipped LSM303DLHC imu which is shown as being supported on the imu documentation page. I have it connected and using i2cdetect -y 1 indicate addresses 19 and 1e and also on the i2c tab detected addresses. Have tried the pypilot settings without any success. any help or advice would be very welcome
Reply


Messages In This Thread
Adafruit LSM303DLHC - by Johnnysails - 2018-07-09, 04:48 PM
RE: Adafruit LSM303DLHC - by Sailoog - 2018-07-09, 07:36 PM
RE: Adafruit LSM303DLHC - by Johnnysails - 2018-07-10, 06:19 PM
RE: Adafruit LSM303DLHC - by Sailoog - 2018-07-12, 07:06 PM
RE: Adafruit LSM303DLHC - by Johnnysails - 2018-07-19, 03:24 PM
RE: Adafruit LSM303DLHC - by Johnnysails - 2018-07-30, 10:42 PM
RE: Adafruit LSM303DLHC - by ssth@yahoo.com - 2019-02-01, 03:01 AM
RE: Adafruit LSM303DLHC - by seandepagnier - 2019-02-01, 04:01 AM
RE: Adafruit LSM303DLHC - by ssth@yahoo.com - 2019-02-07, 02:01 AM
RE: Adafruit LSM303DLHC - by ssth@yahoo.com - 2019-02-01, 04:27 AM
RE: Adafruit LSM303DLHC - by seandepagnier - 2019-02-07, 04:58 AM
RE: Adafruit LSM303DLHC - by ssth@yahoo.com - 2019-02-07, 11:11 AM
RE: Adafruit LSM303DLHC - by ssth@yahoo.com - 2019-02-10, 10:00 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)