This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Temperature Value not shown in OpenCpn
#3
(2018-09-20, 06:53 AM)SkipperEarly Wrote: No screenshot attached!
I assume you use OpenPlotter on the rpi and you have already set the NMEA 183 generator MDA or XDR sentences.
In older versions of Ocpn only MDA was recognized now I believe both are used.
Anyhow I always set both but keep the frequency down to 5 sec to reduce traffic.

my2cents

It would let me attach the screenshots, returned an error. 
I have set up the NMEA Generator, just used the default OpenCpn button.
Actually Im using openplotter headless, just tried if it works on opencpn on the Pi.

It works on the tablet (android) too. 
I might not have the most current version on the laptop. 
Will try that out, thx!
Reply


Messages In This Thread
Temperature Value not shown in OpenCpn - by zugol - 2018-09-19, 11:55 PM
RE: Temperature Value not shown in OpenCpn - by zugol - 2018-09-20, 11:43 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)