This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
Openplotter hardware (GPS receiver)

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Openplotter hardware (GPS receiver)
Didier B Offline
Senior Member
****
Posts: 340
Threads: 72
Joined: Mar 2016
Reputation: 12
#6
2018-10-01, 06:51 PM
I used one of these gps usb on board for a 4 weeks summer cruise, without any inconvenient. On my (aluminium) boat is a big plexiglas "buble" (1 sqm) under which it is located. It is connected through a powered usb hub, and it worked flawlessly without even powering the hub !
I guess in a fiberglass boat you can locate it under the deck, far from any metallic gear, avoiding any corrosion or water inlet.
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN  5.8.4 :  Thank you  Thank you  Thank you


Find
Reply


Messages In This Thread
Openplotter hardware (GPS receiver) - by sapers - 2018-09-28, 07:45 AM
RE: Openplotter hardware (GPS receiver) - by Didier B - 2018-10-01, 06:51 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)