2018-12-11, 12:48 PM
Well I have it working the ESP32 is a bit different so i had to change stuff like interrupts and your method to get ADC reading. Wifi seems fine.
It would be nice to have a configuration page so i can do initial setup and change configuration for thing like ports, speed, compensation.. I have to test the wifi ota stuff better.
I started to think about a PCB board. Trying to change from Fritzing to Kicad...
Since this is mounted on the top of the mast I want waterproof connectors for the Davis. Finding a IP67 RJ11 jack is a pain.I might have to change to a small round 4 pin connector.
It would be nice to have a configuration page so i can do initial setup and change configuration for thing like ports, speed, compensation.. I have to test the wifi ota stuff better.
I started to think about a PCB board. Trying to change from Fritzing to Kicad...
Since this is mounted on the top of the mast I want waterproof connectors for the Davis. Finding a IP67 RJ11 jack is a pain.I might have to change to a small round 4 pin connector.