This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need help setting up Pypilot
#1
I need a little help getting the motor controller working.
I have the serial connected to a serial to USB adaptor.
USB to TTL Serial Cable - Debug / Console Cable for Raspberry Pi
PRODUCT ID: 954

4pin connector         USB adaptor
brown vcc                Red    +5v
black GND                Black GND
white RX                  Green TX
blue TX                    White RX

Power to Controller
1 long beep
Bullet connectors to motor.

I see the USB device
cat /dev/ttyUSB1 nothing
Device setup in openplotter
name   device                 assignment
Servo   /dev/ttyUSB1      pypilot
When I enable basic autopilot In openplotter/pypilot I lose GPS? 

What did i mess up?
Reply


Messages In This Thread
Need help setting up Pypilot - by ddelorme - 2019-01-06, 02:54 PM
RE: Need help setting up Pypilot - by ddelorme - 2019-01-06, 04:34 PM
RE: Need help setting up Pypilot - by ddelorme - 2019-01-09, 01:17 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)