2019-06-12, 03:51 PM
Hm, can't get it to work :-(.
I have tested with both variants of overlay:
Setup 2 Teensy 3.2, one using "Nmea simulator" and one using "Nmea Reader". Both using 115200 as serial speed.
And here I can see a lot of messages. Then added MCP2515 module (incl 3.3V + 5V fix) to Raspberry, also on same N2k network. Adjusted speed in Raspberry also to 115200.
I can see the device can0, "cansend" gives no errors, but no messages at all with candump? And also no extra signalk paths in Dashboard. Also setup N2K both in openplotter and Signalk server according to above.
Any tips?
/Leif
I have tested with both variants of overlay:
Code:
dtoverlay=spi1-1cs
AND:
dtoverlay=spi-bcm2835-overlaySetup 2 Teensy 3.2, one using "Nmea simulator" and one using "Nmea Reader". Both using 115200 as serial speed.
And here I can see a lot of messages. Then added MCP2515 module (incl 3.3V + 5V fix) to Raspberry, also on same N2k network. Adjusted speed in Raspberry also to 115200.
I can see the device can0, "cansend" gives no errors, but no messages at all with candump? And also no extra signalk paths in Dashboard. Also setup N2K both in openplotter and Signalk server according to above.
Any tips?
/Leif