2019-11-10, 10:22 PM
(2019-10-31, 08:55 PM)glowntiger Wrote: Hi Max,Everything ok with your boat card? We hope that Sailoog also proceeds with OP 2 ...
sometimes it is quiet difficult with opensource… The Coder are realy good, but the documentation in´t… ;-)
For The MCS:
The App install the kernel driver for the Serial ports ttySC0-5 and load the Kernel driver for the 1-wire.
All for the CAN do the App of Sailoog. The availible CAN on the Settings page only display the Interface (ifconfig).
Have you restarted your Pi after you have configurate the CAN?
You can check if there are incoming messages with type:
Code:candump can0
Then you should the the raw data of can0
Today I have tested a complete System with:
-MCS
-B&G Vulcan7
-DST200 (STW, Depth, Water temp)
-Seatalk1 to Seatlakng (with ST60+ wind, and ST4000+ Autopilot
All works fine.
The Data of the DS18B20 was shown on the Vulcan7, all datas are displayed in SignalK and on the Plotter.
Realy cool!!!!
Tomorrow Im on the Boat and want to test the AIS through NMEA0183 to N2K...
By the Way, if you want to use Serial Ports (NMEA0183) in SignalK, you can use the interface as example ttySC0 directly….