This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
Connect two i2c sensors in OpenPlotter 1.2.0

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Connect two i2c sensors in OpenPlotter 1.2.0
pgorab Offline
Junior Member
**
Posts: 11
Threads: 2
Joined: Feb 2019
Reputation: 0
#10
2019-06-13, 11:14 PM
(2019-06-13, 12:41 AM)jim321 Wrote: a few things to check.
setup in i2c tab "environmental outside temp"
tools / nmea 0183 generator / opencpn defaults
wiring.

Thanks a lot Jim
Wiring seems to be ok. BME 208 seems to be recognized. Please see the image with the I2C tab, NMEA generator , signal K diagnostic and Open CPN. Pressure and pressure history are 0 and temperature is 273,1!

What should be wrong here?

Thanks in advance!

Paulo
Find
Reply


Messages In This Thread
RE: Connect two i2c sensors in OpenPlotter 1.2.0 - by pgorab - 2019-06-13, 11:14 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)