2019-05-29, 03:47 PM
Jim, thanks for checking, maybe there's an issue with my B+Pi or technique.
I just tried again. Step by step
burned a fresh 1.0.img to micro SD
booted Pi with ethernet cable attached
there were no network connections, set wifi country displayed in network manager tab
after OP runs thru it's script it ends with couldn't update confirming no net
I went into both preferences and set locale and OP to set net to client and eth0
reboot, still nothing...
It seems like some network related changes I make to locale, aren't persistent across reboots no matter where or how I make the changes. If I sudo raspi-config nothing sticks, if I use the gui menu to set wifi country it won't stick after a reboot. When I boot back up it's stuck in GB.
Maybe there is an issue with the board.... When I plug the same ethernet line into my laptop it works fine. I still can't get wifi without nano'ing to wpa-supplicant file to permanently read US vs. GB. and no matter how I try it won't use eth0 even though ifconfig shows it's up.
When you initially boot up what steps do you take? Do you have eth0 access right away? Are you booting from USB or Micro SD?
I'm somewhat of a Raspi noob & new to OP, I'm not a linux noobÂ
My Pi isn't completely crippled it will run OP, oCpn, and seems to play fairly well with other devices but I'd like to upgrade it and I'm stumped why I'm having so many network issues.
I don't suppose you'd put that 1.2.img file on DropBox would ya?
I just tried again. Step by step
burned a fresh 1.0.img to micro SD
booted Pi with ethernet cable attached
there were no network connections, set wifi country displayed in network manager tab
after OP runs thru it's script it ends with couldn't update confirming no net
I went into both preferences and set locale and OP to set net to client and eth0
reboot, still nothing...
It seems like some network related changes I make to locale, aren't persistent across reboots no matter where or how I make the changes. If I sudo raspi-config nothing sticks, if I use the gui menu to set wifi country it won't stick after a reboot. When I boot back up it's stuck in GB.
Maybe there is an issue with the board.... When I plug the same ethernet line into my laptop it works fine. I still can't get wifi without nano'ing to wpa-supplicant file to permanently read US vs. GB. and no matter how I try it won't use eth0 even though ifconfig shows it's up.
When you initially boot up what steps do you take? Do you have eth0 access right away? Are you booting from USB or Micro SD?
I'm somewhat of a Raspi noob & new to OP, I'm not a linux noobÂ
My Pi isn't completely crippled it will run OP, oCpn, and seems to play fairly well with other devices but I'd like to upgrade it and I'm stumped why I'm having so many network issues.
I don't suppose you'd put that 1.2.img file on DropBox would ya?