2019-05-30, 01:12 PM
Are you disappointed because it looks like it has been used? If it's used, it's known to work, but these controllers don't actually wear out or anything like that.
The controller has 4 wires to the pi:
Brown - 3.3v (pin 1)
White - TX (pin 8)
Blue - RX (pin 10)
Black - GND (pin 6 or 9)
The 3.5mm bullet connectors are for the motor/
The red and black wires are for power.
I will post a datasheet on the site soon.
The controller has 4 wires to the pi:
Brown - 3.3v (pin 1)
White - TX (pin 8)
Blue - RX (pin 10)
Black - GND (pin 6 or 9)
The 3.5mm bullet connectors are for the motor/
The red and black wires are for power.
I will post a datasheet on the site soon.