This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
pass depth info in dashboard ?
#1
My installation colleects NMEA info from my aged ST50 througn an NMEA sender located in the ST50 repeater. I can see it in kplex diagnostic window, the sentence is DBT (depth below transducer) and the value is in feet, and I have no way to change that.
OP's NMEA generator seems to only kow DBS (depth below surface) .
Any suggestion ? Any chance to use that data which is in OP ?
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN  5.8.4 :  Thank you  Thank you  Thank you


Reply


Messages In This Thread
pass depth info in dashboard ? - by Didier B - 2019-06-07, 04:51 PM
pass depth info in dashboard ? - by tkurki - 2019-06-07, 08:09 PM
RE: pass depth info in dashboard ? - by abarrow - 2019-06-08, 09:55 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)